12
K
TT
L
F
J
UU
VV
12
Attaching the light kit mounting
plate to the mounting ring
Remove one of the three light kit mounting plate screws
(RR) from the mounting ring (SS) and loosen the other two
screws. (Do not remove.)
Place the key holes in the light kit mounting plate (J) over
the two screws (RR) previously loosened from the mounting
ring (SS). Turn the light kit mounting plate (J) until the light
kit mounting plate (J) locks in place at the narrow section of
the key holes.
Securely tighten the two light kit mounting plate screws (RR)
previously loosened and the one (RR) previously removed.
13
Attaching the LED light kit
and light cover
CAUTION:
Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
Remove one of the three light kit mounting screws (TT) from
the light kit mounting plate (J) and loosen the other two
screws (TT). (Do not remove.)
While holding the 24W LED light kit (K) under the fan motor
assembly (F), make the 2-pin wire connections:
- White to white - Blue to black
Place the key holes in the 24W LED light kit (K) over the two
mounting screws (TT) previously loosened from the light kit
mounting plate (J). Turn the 24W LED light kit (K) until the
24W LED light kit (K) locks in place at the narrow section of
the key holes. Secure by tightening the two light kit mounting
screws (TT) previously loosened and the one previously
removed.
Position the notches (UU) in the outer rim of the 24W LED
light kit (K) so they line up with the tabs (VV) on the inside of
the rim on the light cover (L). Carefully lift the light cover (L)
up inside the 24W LED light kit (K) and secure it to the fan
by turning the light cover (L) clockwise until snug. DO NOT
OVERTIGHTEN.
F
J
RR
SS
Assembly — Installing the Light Kit
