Assembly
1
Preparing the canopy
3
Assembling the fan
WARNING:
Failure to properly install the cotter pin (GG) could
result in the fan loosening and possibly falling.
NOTE:
If a longer downrod (not included) is needed, take out
the screw located in the hanger ball (KK), lower the hanger ball
(KK) and remove the cross pin (LL). Remove all three pieces
from the downrod and assemble them onto the new longer
downrod before proceeding to the downrod installation.
Carefully feed the motor wires and safety cable (MM) up
through the downrod (NN). Thread the downrod (NN) into the
collar.
Align the holes and replace the clevis pin (HH) and cotter
pin (GG). Tighten the two collar setscrews (II).
Slip coupling cover (E), canopy bottom cover (C), and
canopy (B) onto the downrod (NN).
Carefully reinstall the hanger ball (KK) onto the downrod
(NN). Tighten the setscrews (JJ) by using the hex wrench
(EE) provided. Make sure the cross pin (LL) is in the correct
position, the setscrews (JJ) are tightened and wires are not
twisted.
Preparing the motor
2
Remove the cotter pin (GG) and clevis pin (HH), and loosen
the two collar setscrews (II) from the motor collar.
Loosen two setscrews (JJ) located in the hanger ball (KK) by
using the hex wrench (EE) provided. Lower the hanger ball
(KK) and remove the cross pin (LL). Remove the hanger ball
(KK) from the hanger ball/downrod assembly (D).
JJ
D
KK
GG
HH
II
II
Remove the canopy bottom cover (C) from the canopy (B) by
turning the canopy bottom cover (C) counterclockwise.
Remove the mounting bracket (A) from the canopy (B) by
removing the non-slotted canopy mounting screw (FF) from
the bottom of the canopy (B) and loosening the slotted
canopy mounting screw (FF) a half turn from the screw
head. Next, turn the canopy (B) counterclockwise to remove
the mounting bracket (A) from the canopy (B).
FF
A
B
C
FF
LL
EE
C
F
E
B
II
II
HH
GG
JJ
JJ
LL
EE
NN
KK
MM
Please contact 1-800-986-3460 for further assistance.
HOMEDEPOT.COM/HOMEDECORATORS
7
JJ
