DD
MM
OO
OO
D
KK
A
F
8
Assembly — Hanging the Fan
4
Installing the mounting bracket to the
electrical box
WARNING:
To reduce the risk of fire, electric shock or other
personal injury, mount the fan only to an outlet box or supporting
system marked acceptable for fan support and use the mounting
screws provided with the outlet box.
Pass the 120 volt supply wires through the center hole in
the mounting bracket (A).
Install the mounting bracket (A) to the outlet box with the
screws and washers provided with your outlet box.
Securely tighten the two mounting screws.
WARNING:
The tab in the ring must rest in the groove of
the hanger ball/downrod assembly (D). Failure to properly seat
the tab in the groove could cause damage to the wiring.
Hanging the fan to the mounting
bracket
5
Remove two screws (OO) from two upper sides of hanger
ball (KK).
Carefully lift the fan motor assembly (F) up to the mounting
bracket (A) and seat the hanger ball/downrod assembly (D)
in the mounting bracket (A) socket.
Securely tighten two screws (OO).
Secure the safety cable (MM) to the building structure that
independent to the outlet box using safety cable screw, lock
washer and flat washer (DD) (included). The safety cable
should be in a stress-free state after installation.
A
Outlet Box
