Assembling the tree
Please remove protective covers from the base of the pole for each tree
section before assembling.
Step 1. Insert tree bottom (C) into the tree stand and tighten the screw.
(See Fig. 1)
Step 2. Insert middle section (B) into the tree bottom (C). (See Fig. 2)
Step 3. Insert tree top (A) into the middle section (B). (See Fig. 3)
Step 4. Allow branches to fall into place or gently pull branches up and out.
When adjusting branches be sure that all wires are free of branch
hinges. (See Fig. 4)
Step 5. Shape the branches. Starting with tips closest to the pole, shape
one tip to the right, one to the left and one at the center of the main
stem. Repeat pattern for each branch. (See Fig. 5)
Step 6. Plug the power cord into a proper outlet. This tree comes with a
control box and a remote control. You can change the lighting
patterns of the tree by using control box or remote control.
Please see Instructions of control box and remote control as
below.
Operation
Turning on the tree
Step 1. Connect each tree section well and plug the power cord into a wall
outlet.
Instruction of control box and remote
control
Instruction of control box
1.
Press the button on control box to turn on and off the lights or timer
function.
2.
Press and hold the button on control box to activate timer mode,
select below timer hours:
i.
The first indicator lights of timer on control box turn on:
The tree lights will automatically run through a 2-hours
ON, 22-hours OFF cycle.
ii.
The second indicator lights of timer on control box turn on:
The tree lights will automatically run through a 4-hours
ON, 20-hours OFF cycle.
iii.
The third indicator lights of timer on control box turn on:
The tree lights will automatically run through a 6-hours
ON, 18-hours OFF cycle.
iv.
The fourth indicator lights of timer on control box turn on:
The tree lights will automatically run through an 8-hours
ON, 16-hours OFF cycle.
To turn off the timer function, press the button on control box or press
the off button on remote control.
There is memory mode on timer control even unplug and re-plug back on.
Instruction of remote control
Please note this tree has a remote control.
Please pull out the insulation tape from the remote control, before starting
to use it.
1.
Press the button ON or OFF to turn on or off the lights or timer function.
2.
Press the 2H, 4H, 6H or 8H button to select the different timer hours.
If the remote control does not work, check whether the battery of the
remote control is out of power.
To replace the remote control battery:
1.
Replace with a new button cell “CR2025” (3 volt) into
the compartment.
CAUTION:
DO NOT DISPOSE OF
BATTERIES IN FIRE. BATTERIES MAY EXPLODE
OR LEAK.
Use and Care Instructions
a)
Before using or reusing, inspect product carefully. Discard any
products that have cut , damaged, or frayed wire insulation or cords,
cracks in the lampholders or enclosures, loose connections, or
exposed copper wire.
b)
When storing the product, carefully remove the product from wherever
it is placed, including tree, branches, or bushes, to avoid any undue
strain or stress on the product conductors, connections, and wires.
c)
When not in use, store neatly in a cool, dry location protected from
sunlight.
Care and Cleaning
Step 1. Remove all ornaments and decorations.
Step 2. Unplug the power cord from the wall outlet.
Step 3. Gently lift the tree top straight up to remove from the center section
and fold all branches towards the pole.
Step 4. Repeat this step for the center and bottom tree sections.
Step 5. Carefully place all tree sections into a shipping box and tape it shut.
Step 6. Store your tree in a cool, dry place away from sunlight.
