9
Figure 17
Touching Ceiling
Blade Balancing
If deviation is greater than 1/8”, please call
Customer Service (01-800-004-6633) to order
complimentary replacements of your brackets.
All blades are grouped by weight during
assembly. The following procedure should correct
most fan wobble. Check after each step.
Verify that all blades and blade bracket screws
are secure (most fan wobble problems are
caused by loose parts). Once the fan is properly
installed, run the ceiling fan for 10 minutes to
let the fan self-adjust.
If wobble occurs after running the fan for 10
minutes, verify blade level using the following
process:
Select a point on the ceiling above the tip of one
of the blades, then select any fan blade and
measure from the center of the selected blade to
the point on the ceiling (as shown in Figure 17).
Rotate the fan until the next blade is positioned
and repeat the measurement using the same
point from the ceiling for every blade.
Measurement deviations should be within 1/8”.
If all deviations are less than 1/8” and the fan
continues to wobble, please call Customer
Service (01-800-004-6633) to order a
complimentary Blade Balancing Kit.
1.
2.
-
-
Installing the Mounting
Plate
Remove 1 of the 3 screws from the mounting
ring and loosen the other 2 screws. (Do not
remove)
Place the key holes on the mounting plate over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Figure 18)
1.
2.
Figure 18
Moounting Plate
Mounting Ring
Screws
