12
Assembly - Attaching the Light
Attaching the light kit fitter assembly
and installing the light bulbs
2
□
Remove one screw (LL) from the light kit pan (G), and loosen,
but do not remove the other two screws.
□
Connect the wires from the light kit fitter assembly (H) to
the wires from the fan motor assembly (E) by connecting the
molded adaptor plugs together. Carefully tuck all wires and
splices into the switch cup.
□
Push the light kit fitter assembly (H) up to the light kit pan (G)
so that the two loosened screw heads fit into the keyhole slots.
Turn the light kit fitter assembly (H) clockwise to secure.
□
Re-install the screw (LL) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
□
With power off, install the two light bulbs,(6.5-watt maximum
included)(M) by screwing into the light bulbs sockets.
CAUTION:
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
Installing the crystal shade
3
□
Remove the three screws (PP) from the light kit pan (H).
□
Align the hook (XX) on the crystal shade (I) with the round
hole at the outer rim of the light kit pan (H) and hang the
crystal shade (I) to round hole in place.
□
Carefully push up the crystal shade (I) to the light kit pan (H),
align the three screws holes on the crystal shade (I) with the
three screws holes on the light kit pan (H).
□
Re-install the three screws (PP) removed in step 1 and tighten
the screws to secure the crystal shade (I) properly.
CAUTION:
Make sure the power is off before attaching or
removing the crystal shade.
WARNING:
Allow the crystal shade to cool completely
before removing.
Attaching the light kit pan
1
□
Remove one screw (OO) from the black bracket below fan
motor assembly (E), and loosen, but do not remove the other
two screws.
□
Push the light kit pan (G) up to the black bracket so that the
two loosened screw heads fit into the keyhole slots. Turn the
light kit pan (G) clockwise to secure.
□
Re-install the screw (OO) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
M
G
LL
H
E
OO
G
H
I
PP
XX
