7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
□
Remove the canopy ring (FF) from the canopy (C) by turning
the ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (JJ) located in the “L
shaped” slots.
□
Remove and save the two canopy screws (II) in the round
holes. This will enable you to remove the mounting bracket
(A).
□
Route the wires exiting the top of the fan motor
assembly (E) into the decorative motor collar cover (D)
and through the canopy ring (FF).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
2
3
1
FF
II
JJ
A
C
□
Loosen, but do not remove the setscrew (DD) on the motor collar
(M) on top of the fan-motor assembly (E) by turning it counter-
clockwise.
□
Install the downrod (B) by inserting it into the motor collar (M),
and turning it clockwise until it is tight.
□
Re-tighten the setscrew (DD) on the motor collar (M) on top of the
fan-motor assembly (E) by turning it counterclockwise.
NOTE:
This fan is equipped with a safety tab (EE). Should
the setscrew (DD) ever become loose while the fan is
running in reverse, the safety tab (EE) will engage and
stop the fan from falling.
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(DD) must be completely tightened
C
B
FF
D
E
M
EE
DD
C
B
FF
D
E
