9
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Hanging the Fan (continued)
Preparing the remote control
3
□
Remove the battery cover by pressing firmly on the arrow and sliding the cover
off.
□
Install two 1.5V AAA batteries (J) (included).
□
Confirm that the power to the fan is off at either the wall switch or breaker box.
□
Return power to the fan at the wall switch or breaker box.
□
If the remote control doesn’t work as normal, press then release the “Learn” button
for 1-2 seconds, located in the remote’s battery compartment, within 30 seconds of
turning on the power.
□
If pairing is successful, the blades will begin to spin.
□
Replace the battery cover on the remote control.
1 to 3 mode
□
To use more than one remote control for your fan, press the “Learn” button for 10
seconds and release. Once pairing is successful, the blades will begin to spin.
□
Repeat the above process for the remote controls you want to work with this fan.
□
The fan can be only controlled by 3 remote controls maximum at the same time
after “Learning”. If you use a forth remote control to handle the fan, the first remote
control will be replaced .
1 to 1 mode
□
To use only one remote control for your fan, press and release the “Learn” button
for 1-2 seconds. The “1 to 3” mode will be cleared and returned back to “1 to 1”
mode.
NOTE:
The remote control has already been paired to the ceiling
fan for your convenience. If you have two of the same model fans
in your home, please follow the steps below to control each fan
independently.
NOTE:
The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will damage
the remote control. Dispose of used battery properly and keep the
battery out of the reach of children.
Installing the receiver
□
Position the house supply wires (AAA) to one side of the slide-on
mounting bracket (A); position the fan wires to the opposite side.
□
Insert the narrow end of the receiver (I) (as shown, flat side
towards the ceiling) into the slide-on mounting bracket until it
rests on top of the ball/downrod assembly.
4
WARNING:
To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring
must meet all local and national electrical code
requirements. The electrical source and fan must
be 110/120 volts, 60Hz. Do not use this product in
conjunction with any variable wall control. Incorrect
wire connection can damage this receiver.
CAUTION:
If other fan wires are a different color, have
this unit installed by a licensed electrician.
I
A
AAA
C
JJ
D
B
I
