11
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Attaching the Blades to Blade Bracket
Attaching the fan blades to blade
bracket
1
□
Attaching the blades to blade bracket by using the blade
attachment screws (AA) and Medallion (H) provided, insert
a blade attachment screw (A) through a hole in the blade
bracket(G) and blade (F) and into the medallion (H).Repeat these
steps for the remaining blades (F).
□
Repeat step 1 for attaching the remaining medallions (H).
□
Firmly tighten each screws to secure.
Assembly - Hanging the Fan (continued)
Mounting the fan-motor assembly
(standard mount)
□
Align the locking slots of the canopy (C) with the two screws
(DD) and alignment post (KK) in the mounting bracket (A).
□
Push up the canopy (C) and turn clockwise until the
alignment post (KK) engage to the round hole and the
screws (CC) engage to the key slots.
□
Firmly tighten the two mounting screws (DD).
□
Install the decorative bottom cover (EE) by aligning the cover
slots with screws in the bottom of the canopy (C). Rotate the
bottom cover (EE) clockwise to lock in place.
7
WARNING:
When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
C
A
DD
EE
B
E
KK
Fasten the blade assemblies to the
motor
2
□
Insert the blade/blade bracket assemblies through the hole in
the side of the center flywheel on the fan-motor assembly (E),
align the two screw holes on blade bracket (G) with two screw
holes on the center flywheel and secure with screws (BB).
□
Repeat this step for the remaining blade assemblies.
E
G
BB
G
AA
H
F
