12
Assembly - Attaching the Light Kit
Installing the light kit fitter assembly
2
□
Remove one screw (QQ) from the light kit pan (I) and
loosen, but do not remove the other two screws.
□
Connect the wires from the light kit pan (I) to the wires
from the fan motor assembly (E) by connecting the molded
adaptor plugs together. Carefully tuck all wires and splices
into the switch cup.
□
Push the light kit fitter assembly (J) up to the light kit
pan (I) so that the two loosened screw heads fit into
the keyhole slots. Turn the light kit fitter assembly (J)
clockwise to secure.
□
Re-install the screw (QQ) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
CAUTION:
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit pan.
Installing the shatter resistant bowl
3
□
Place the shatter resistant bowl (K) into the light kit pan (I),
aligning the three flat areas on the top flange of the shatter
resistant bowl (K) with the three raised dimples in the light
kit pan.
□
Turn the shatter resistant bowl (K) clockwise until it stops.
CAUTION:
Make sure the power is off before attaching or
removing the shatter resistant bowl.
WARNING:
Allow the shatter resistant bowl to cool completely
before removing.
□
Remove one screws (NN) form the black bracket below the fan
motor assembly (E). Loosen but do not remove the other two
screws.
□
Attach the light kit pan(I) to the fan motor assembly (E) by
securing with the two screws (NN) loosened in first step. Push
the light kit pan (I) up to engage the screw heads in the screw
slots and turn to secure. Tighten each screw firmly.
Attaching the light kit pan
1
E
I
NN
I
K
I
J
