11
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Attaching the Blades
Attaching the blades to the blade
brackets
1
□
Attach a blade (F) to blade bracket (I) by inserting the screws
(AA) into the holes in the blade (G) and through the blade
bracket (I).
□
Tighten each screw securely.
□
Repeat this step for each blade and blade bracket.
Fastening the blade assemblies to
the motor
2
□
Fasten the blade/blade bracket assembly to the fan motor
assembly (E) by inserting the alignment post into the slot on
the bottom of the motor and tightening the pre-installed blade
bracket screws (RR).
□
Repeat this step for the remaining blade assemblies.
Assembly - Hanging the Fan (continued)
Mounting the fan-motor assembly
(standard mount)
□
Align the locking slots of the canopy (C) with the two
screws (DD) and alignment post (KK) in the mounting
bracket (A).
□
Push up the canopy (C) and turn clockwise until the
alignment post (KK) engage to the round hole and the
screws (DD) engage to the key slots.
□
Firmly tighten the two mounting screws (DD).
□
Install the decorative bottom cover (FF) by aligning the
cover slots with screws in the bottom of the canopy
(C). Rotate the bottom cover (FF) clockwise to lock in
place.
7
WARNING:
When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
KK
A
DD
C
B
FF
E
I
F
AA
RR
E
F
