12
Assembly - Attaching the Light
Attaching the light kit fitter assembly
2
□
Connect the wires from the light kit fitter assembly (H) to
the wires from the fan motor assembly (E) by connecting
the molded adaptor plugs together. Carefully tuck all wires
and splices into the switch cup.
□
Place the light kit fitter assembly (H) into the light kit pan
(G), aligning the three flat areas on the top of the flange
of the light kit fitter assembly (H) with the three raised
dimples in the light kit pan (G).
□
Turn the light kit fitter assembly (H) clockwise until it
stops.
CAUTION:
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
Attaching the light kit pan
1
□
Remove one screw (SS) from the black bracket below fan
motor assembly (E), and loosen, but do not remove the
other two screws.
□
Push up the light kit pan (G) to the black bracket so that
the two loosened screw heads fit into the keyhole slots.
Turn the light kit pan (G) clockwise to secure.
□
Re-install the screw (SS) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
G
SS
H
G
