7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
Ƒ
Remove the canopy ring (L) from the canopy (C) by turning
the ring counterclockwise until it unlocks.
Ƒ
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (CC) located in the “L
shaped” slots.
Ƒ
Remove and save the two canopy screws (DD) in the round
holes. This will enable you to remove the mounting bracket
(A).
Ƒ
Route the wires exiting the top of the fan-motor
assembly (E) through the center of the canopy ring (L).
Ƒ
Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (D) onto the end
of the ball/downrod (B). Make sure the slots on the
canopy (C) are on top.
Ƒ
Route the wires exiting the top of the fan motor
assembly (E) through the downrod as shown.
2
3
1
C
A
L
DD
CC
C
D
E
L
B
M
E
B
FF
EE
Ƒ
Loosen, but do not remove, the setscrew (EE) on the motor
collar (M) on top of the fan motor assembly (E) by turning it
counterclockwise.
Ƒ
Install the downrod (B) by inserting it into the motor collar (M),
and turning it clockwise until it is tight.
Ƒ
Re-tighten the setscrew, (EE) on the motor collar (M) on top of
the fan motor assembly (E), by turning it clockwise.
56;,!
This fan is equipped with a safety tab (FF). Should
the setscrew (EE) ever become loose while the fan is
running in reverse, the safety tab (FF) will engage and
stop the fan from falling.
*(<;065!
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(EE) must be completely tightened
