9
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Hanging the Fan (continued)
4
Installing the receiver
Ƒ
Position the house supply wires (AAA) to one side of the
slide-on mounting bracket (A); position the fan wires (BBB)
to the opposite side.
Ƒ
Insert the narrow end of the receiver (J) (as shown, flat side
towards the ceiling) into the slide-on mounting bracket until
it rests on top of the ball/downrod assembly.
>(9505.!
To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements.
The electrical source and fan must be 110/120 volt, 60Hz.
Do not use this product in conjunction with any variable wall
control. Incorrect wire connection can damage this receiver.
*(<;065!
If other fan wires are a different color, have this
unit installed by a licensed electrician.
*(<;065!
Do not install the receiver in a damp location or
immerse in water (For indoor use only). Do not pull on or cut
the receiver leads shorter. Do not drop or bump the unit.
B
C
AAA
BBB
A
J
WINK antenna
mount to ceiling using wood screw (included)
Receiver antenna
(Leave connected and do not cut)
56;,!
The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
hand unit. Dispose of used battery properly and keep the
battery out of the reach of children.
56;,!
For better performance with the WINK system, the
T-Shaped antenna stick should be mounted to the ceiling
outside of the fan’s ceiling canopy using the pre-mounted
double-stick tape and wood screw (XX) (included).
