7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
□
Route the wires exiting the top of the fan-motor
assembly (D) through the canopy ring (K) (make sure
the slot openings for the canopy ring (K) are on top).
□
Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (F) onto the end
of the ball/downrod (B). Make sure the slots on the
canopy (C) are on top.
□
Route the wires exiting the top of the fan motor
assembly (D) through the downrod (B) as shown.
2
3
1
K
C
A
JJ
LL
DD
M
D
B
EE
C
F
□
Loosen, but do not remove the setscrew (DD) on the motor collar
(M), on top of the fan-motor assembly (D) by turning it counter-
clockwise.
□
Install the downrod (B) by inserting it into the motor collar (M),
and turning it clockwise until it is tight.
□
Re-tighten the setscrew (DD) on the motor collar (M) on top of the
fan-motor assembly (D) by turning it counterclockwise.
NOTE:
This fan is equipped with a safety tab (EE). Should
the setscrew (DD) ever become loose while the fan is
running in reverse, the safety tab (EE) will engage and
stop the fan from falling.
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(DD) must be completely tightened
□
Remove the canopy ring (K) from the canopy (C) by turning
the ring clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (LL) located in the “L
shaped” slots.
□
Remove and save the two canopy screws (JJ) in the round
holes. This will enable you to remove the mounting bracket
(A).
K
C
B
F
D
