11
Operation
NOTE: When the heat function is used for the first time, a slight
odor may be present. This is normal and should not occur again
unless the heater is not used for an extended period of time.
1
Using the Control Panel
□
Check that the heater outlet grill is not covered or
obstructed in anyway, and make sure the power to the unit
is switched on.
□
The fireplace can be accessed in two ways: Using the
touchpad control panel, or using the multifunction remote
control unit.
□
Press the appropriate button to operate your fireplace:
3
1. Main Power Button:
This button supplies power to
all of the fireplace functions. It must be turned on for
the fireplace to work.
2. Heater Control Button:
This button controls the
heater ON/OFF and 11 temperature modes from 68°F
(20°C) to 88°F (31°C) . When the heater is first turned
on, it will come on at the lowest room temperature
setting. The log set will remember the last heat
setting and in later use the heater will start at that
setting, unless power to the unit has been interrupted.
Each time the temperature button is pressed, the
temperature set point increases, allowing you to adjust
the ambient temperature.
3. Flame Control Button:
This button controls the
brightness of the flame effect with settings at High,
Medium, and Low. When the log set is first turned on,
the flame will come on at the highest setting. The log
set will remember the last flame setting used and in
later use the flame brightness will start at that setting,
unless power to the unit has been interrupted. Each
time the flame button is pressed, the flame brightness
decreases. The only way to turn off the flame effect
completely is to turn off the main power button (1).
4. Timer Button:
This button controls the ON/OFF and
10-time setting from 30 minutes to 9 hours. When the
Timer is first turned on, it will come on at the shortest
time setting (30 minutes). Each time the Timer button
is pressed, the time increases 1 hour, up to the
longest setting (9 hours). Once the set time expires, all
fireplace functions will be automatically turned off.
5. Fahrenheit/Celsius display:
This button displays
F (Fahrenheit) or C (Celsius) depending on how the
temperature mode is set. When the fireplace is turned
on, the Fahrenheit (F) temperature will be displayed.
To switch from Fahrenheit to Celsius, or vise-versa,
when the HEATER is ON, hold HEATER CONTROL button
for 10 seconds. The fireplace will remember the last
temperature mode setting, and in later use, the display
will start at that setting, unless power to the unit has
been interrupted.
6. Temperature/Timer display:
This LED display
shows the set point for the temperature and timer
functions. When either of these functions is activated,
the display reflects the set point for five seconds and
then fades to black. Any change in the set point of the
temperature or timer will reactivate the display, which
again fades after five seconds.
6
2
4
1
5
1
4
3
2
