ITEM # ACNS18V BRAD NAILER/STAPLER
4
LED Red on=Low battery
LED Red flashing=The nails/staples are jammed.
LED Green on=No nails, power tool in dry fire protection
LED Green flashing=Overheat / power tool in overheat protection mode
(
The tool cannot fire in this situation, wait until it has cooled down
)
Charger:
Red LED on=Battery charging.
Green LED on=Battery fully charged.
OPERATING INSTRUCTION
Battery Charging: Battery packs for this tool are shipped in a low charge condition to
prevent possible problems.
a)
Insert the power outlet into the port on battery pack. Plug the charger power supply into a
power outlet. The indicator light on the charger will be red (battery is charging).
b)
When batteries become fully charged (about 1~1.5 hours), the indicator on the charger will
turn green. Unplug the charger from power supply and remove the battery pack.
NOTE:
A battery that is new or has not been used for a longer period does not develop its full
capacity until after approx. 5 charge/discharge cycles.
Do not recharge the batteries after use if they are not to be used for an extended period of time.
Recharge the batteries as and when they are required.
Do not recharge the recharge-required batteries after use if they are not cool down. Otherwise it
will be not charged fully.
Inserting and Removing the Battery Pack
a)
Insert the battery pack into the grip until it clicks in place.
b) To remove the battery pack, with pressing the lock buttons simultaneously to pull the pack out of
the machine.