6
Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use.
To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact service center for inspection.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Place steam iron on the ironing board carefully.
Be careful do not touch metal parts of working surface and water tank during operation.
Avoid of ironing zippers, rivets, etc., as they can scratch soleplate.
Do not place steam iron on the metal or rough surface.
Move steam iron carefully to avoid burns, because of there could be hot water leakage, as well as hot steam.
USING THE APPLIANCE
SETTING TEMPERATURE
Sort the fabric: wool with wool, cotton with cotton, etc. Start ironing the fabrics requiring the lowest temperature and progress to the higher ones, because the steam iron heats up quicker than it cools
down.
If the fabric consists of various kinds of fibers, start ironing the fabrics requiring the lowest temperature (e.g. article consisting of 60% polyester and 40% cotton should be ironed at the temperature
indicated for polyester (•) and without steam.
Turn the temperature control dial round until it is opposite the setting pointer.
LABEL
TYPE OF TEXTILE
Do not iron this article
•
Synthetics, Nylon, Acrylics, Polyester, Silk
••
Wool, Rayon
•••
Cotton, Linen
FILLING THE WATER TANK
Unplug the steam iron before filling.
Set the temperature controller in OFF position
Hold the steam iron in the horizontal position.
Slowly pour water into the water fill opening with the help of plastic beaker.
Do not fill higher than indication “МАX” of the water tank, in order to avoid spilling out of water.
If you have to refill while ironing, unplug the appliance from the power supply before filling.
EMPTYING THE WATER TANK
The water tank should be emptied after each use.
Unplug the steam iron from the power supply.
While the steam iron is still warm, hold the steam iron over a sink and allow the steam iron to drain by tipping the point of the steam iron down
Gently shake the steam iron to loosen any water drops that may be trapped. The warmth of the iron should dry out any remaining water.
NOTE:
If you empty the water tank after the steam iron has cooled down, set the steam iron in an upright position on its heel rest, plug it in and set the temperature to the maximum, heat for 2 minutes. Unplug
the steam iron from the power supply.
