Important
1. Make sure your WIFI router and its signal strength cover all the socket locations. Please note that a WIFI signal may not penetrate
through concrete walls or solid doors and that, if it does, it is usually SEVERELY reduced. You may therefore need to add one or more
WIFI Repeaters to increase signal coverage. If you do this, then ensure that individual socket are paired to the closest Repeater or
Router. Since all Router/Repeater SSID’s are different, you must ensure that the socket is paired to the correct SSID (see setting up your
WIFI Socket above).
2. After installing a socket, please test it at least a couple of times to check the performance.
Trouble Shooting
CANNOT PAIR THE SOCKET SUCCESSFULLY
1. If there are too many WIFI connections around your socket, turn them off to avoid any disturbance and pair again.
2. Check that the router is working properly and that it operates on 2.4GHz during pairing
3. Check if the WPS function is ENABLE (if the router support WPS)
DOESN’T WORK PROPERLY or LOSS OF SIGNAL ICON APPEARS
1. Check whether the socket is within coverage of your WIFI router/repeater. Move the Router to a different location.
2. Check that the router is working properly
IMPORTANT SAFETY INSTRUCTIONS:
1. Read the instructions. All uses guidelines must be read before start device.
2. Keep the instructions for future use.
3. Attention, use and security guidelines must be respected.
4. The device must not be used near water or be put in contact with moisture.
5. Make sure has no liquid is spilled on device and device openings.
6. Move device carefully, avoid shocks.
7. Do not block the breakdown of the device outputs.
8. Do not place the device near from a heat source (e.g. radiator). Do not expose it to the Sun.
9. Plug the device as indicate on this information form.
10. This device has a connection with overload protection (security device). If the replacement of decision-making is required, please send
to experience or the device manufacturer technician for repairing.
11. For cleaning the device, please follow the recommendations of the notice.
12. The apparatus should be unplugged if a long period out of use.
13. Device shall be repaired by a qualified person when:
a. device was exposes to the rain,
b. device does not work correctly without notable exterior change,
14. The user shall not try to maintain device beyond that which is described in this information form. The guarantee would negate.
15. MAINS plug is used as the disconnect device and shall remain readily operable and easily accessible.
16. To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation instructions.
