P
Paagge
e 5
5
M
MR
RF
F--2
20
00
0 B
B
A
AS
SE
E
S
S
T
TA
AT
TIIO
ON
N
A Standard MRF-200 System
A standard system utilizes no identical components and only one equipment
location. However, you can add any number of MX-800 remote controls to
your home! MX-800’s are available as an accessory purchase without an MRF-
200 for standard system installations that already have an MRF-200.
You can add any number of MRF-200 base stations in a standard system as
well. If you need more than six flasher outputs you may add additional MRF-
200 receivers as needed by ordering an accessory MRF-200 base station.
Do not change the factory default settings in RF Control section of MXEditor
when you download to your MX-800’s. You do not need to utilize MXEditor’s
Program Step 9 (RF Control), since the factory settings will work fine!
Standard Installation — Step by Step
S
Stte
ep
p 1
1 -- P
Prro
oggrraam
m aan
nd
d D
Do
ow
wn
nllo
oaad
d tto
o tth
he
e M
MX
X--8
80
00
0
Connect your MX-800 to your PC and program the IR commands and macros as
you like. Since your MX-800 sends both IR and RF, you can test your program-
ming as you go by pointing the MX-800 at the components and using MXEditor’s
TEST and Macro Play features if you place your laptop PC in the same room as
the components (with the cabinet doors open and in line of sight).
For a detailed explanation of how to program, use the downloadable
Programming Manual or the animated Tutorial. Both are available as free down-
loads from the www.hometheatermaster.com website.
IIm
mp
po
orrttaan
ntt N
No
otte
e:: D
Do
o N
NO
OT
T p
po
ow
we
err u
up
p tth
he
e M
MR
RF
F--2
20
00
0 aatt tth
hiiss p
po
oiin
ntt.. Y
Yo
ou
u n
ne
ee
ed
d tto
o
tte
esstt yyo
ou
urr IIR
R cco
om
mm
maan
nd
dss aan
nd
d M
Maaccrro
oss lliin
ne
e o
off ssiiggh
htt vviiaa IIR
R o
on
nllyy aatt tth
hiiss p
po
oiin
ntt!!
Once you have completed and downloaded your programming to the MX-800
remote control, you are ready to test RF operation via the Front Blaster and
(if necessary) the self-adhesive flashers that connect to the MRF-200’s flasher
line outputs.
S
Stte
ep
p 2
2 -- P
Pllaacce
e tth
he
e M
MR
RF
F--2
20
00
0
The MRF-200 should be placed so that the Front Blaster will control as many
of the system’s A/V components as possible. If you are connecting the out-
board flashers to the rear Flasher outputs only, the MRF-200 may be con-
cealed and mounted to the rear wall or back of the system cabinet.The
mounting plate slides apart from the receiver, screws to the wall or cabinet
