3
160° horizontally.
9. Adjust the PIR Camera angle according to your need.
Step 2: Install the Solar Panel
1. Using the fixing template to mark the position of two fixing
holes. Drill two holes with 25mm in depth and 5mm in
width by inserting the plastic wall plugs supplied.
2. Loosen the screws from the strain relief located on the
base of solar panel. (FIGURE 4)
FIGURE 4
3. Route the solar connecting wire though two strain relief
and fix them in place with screws respectively, leaving
20cm length of connecting wire for further connection.
4. Plug one end of the jacks with 20cm length of connecting
wire to the ‘solar power out’ of rear side of the solar panel.
(FIGURE 4)
5. Plug the other end of the jack to the Camera’s solar jack
socket.
6. Fix the base of solar panel to the plastic wall plugs using
two screws provided. (FIGURE 5)
FIGURE 5
Step 3: Expand the Solar Panel (option)
1. Using the fixing template to mark the position of two fixing
holes. Drill two holes with 25mm in depth and 5mm in
width by inserting the plastic wall plugs supplied.
2. Loosen the screws from the strain relief located on the
base of solar panel. (FIGURE 4)
3. Route the solar connecting wire though two strain relief
and fix them in place with screws respectively, leaving
20cm length of connecting wire for further connection.
4. Plug one end of the jacks with 20cm length of connecting
wire to the ‘solar power out’ of rear side of the solar panel.
5. Plug the other end of the jack to the ‘solar power in’ of the
rear side of the first solar panel. Fix its solar connecting
wire to the strain relief of the base of solar panel, using the
screws provided. (FIGURE 6)
2
nd
. 1
st
.
FIGURE 6
6. Fix the base of solar panel to the plastic wall plugs using
two screws provided.
Operating Instruction
1. When connecting to a 6V/1.2Ah rechargeable battery, the
PIR Camera will enter warm-up period for 1 minute and its
LED will illuminate steadily. During warm-up period, the
PIR Camera will not transmit any radio signal. Once the
PIR Camera is triggered, the camera images can be
viewed from the video devices for 1 minute, then turned
off.
2. When connecting to a 7.5V/300mA adapter (optional), the
PIR Camera will warm up for 1 minute and its LED will
illuminate steadily. During warm-up period, the PIR
Camera will keep emitting radio signal. Once the PIR
Camera is activated, the camera images can be viewed
from the video devices for 1 minute then turned off.
Regardless of no activation, 24h surveillance can be made
via turning on the video devices.
3. Turn on TV or monitor and walk through the detection
coverage of PIR Camera, the camera images can be
viewed instantly.