11
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
A
D
C
E
BB
Assembly - Hanging the Fan (continued)
5
Wrapping the extra wire
□
Gently wrap the excess wire around the mounting bracket.
□
Secure with electrical tape.
4
NOTE:
Follow this step ONLY if you did not cut the extra length off
from the wires coming from the ceiling fan.
Mounting the fan-motor assembly
(standard mount)
□
Align the locking slots of the ceiling canopy (C) with the two
screws (HH) in the mounting bracket (A). Push up to engage
the slots and turn clockwise to lock in place.
□
Immediately tighten the two mounting screws firmly.
□
Install the two mounting screws (HH) (saved from Assembly
Step 1 “Prepairing for mounting”) into the holes in the
canopy (C) and tighten firmly.
□
Install the decorative canopy ring (D) by aligning the ring’s
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
WARNING:
When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
WARNING:
The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
