Assembly — Installing the Light Kit
11
Attaching the light kit to
the switch housing
□
Remove the three light kit mounting screws (II) from
the light kit (H) and keep these screws.
□
While holding the light kit (H) under your fan motor
assembly (E), locate two single white and blue wires
in the switch housing labeled "FOR LIGHT". Make the
polarized plug connections:
- White to white
- Blue to black
□
Carefully push all wires back into the switch housing.
Install the light kit (H) onto the switch housing with
the three light kit mounting screws (II) provided. Be
sure to tighten all screws.
CAUTION:
Before starting the installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
12
Mounting the light bulb and
installing the glass shade
□
Install one 9 watt LED bulb (KK) (included).
□
Mount the glass shade (I) to the light kit by partially
unscrewing the three light holder thumbscrews (JJ)
on the light kit, inserting the glass shade (I), and
gently and evenly tightening the light holder
thumbscrews (JJ) by hand to the glass shade (I). Do
not overtighten.
II
H
E
I
KK
JJ
16
