WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
3. THE FAN WOBBLES
Verify all blades and blade bracket screws are secure (most fan wobble problems are caused by loose parts). Once fan is properly
installed, run the ceiling fan for 10 minutes to let the fan self-adjust.
If wobble occurs a er running the fan for 10 minutes, verify blade level using the following process:
a)
select a point on the ceiling above the p of one of the blades. Then select the fan blade and measure from the center
of t
he selected blade to point on the ceiling. Rotate the fan un l the next blade is posi oned and repeat the
measurement using the same point from the ceiling for every blade. Measurements
should be within 1/8 inch.
4.
LIGHT IS NOT WORKING
Check Bulb to make sure it is installed correctly
Remove non-working bulb and replace with a bulb that is known to be a good working bulb
To reset the remote control: 1) Turn off power to fan using the wall switch or circuit breaker. 2) Remove ba eries from
remote. 3) Wait 10 seconds. 4) Replace ba eries and turn power on
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
12
Summary of Contents for F6277110V
Page 1: ...CEILING FAN ...