6
5. OPERATION
5.1 CONTROL PANEL
5.2 SETTINGS
Power Button
In standby state, press the power button to turn on the unit. The operation indicator lights up, the fan runs
at default high speed, and the default humidity level is 50%.
In power-on state, press the power button to turn off the unit. The running indicator light goes off, the
compressor stops immediately, and the fan shuts down 30 seconds later.
Mode Button
Press the mode key to switch between Automatic and Continuous mode.
●
Auto Mode
:
Humidity level and fan speed are adjustable.
When automatic mode is activated, the target humidity can be set between 30% and 80% in 5% steps using
the “+” and “-” keys.
The dehumidifier starts dehumidifying when the room humidity is at least 3% higher than the set target
humidity.
Note:
when the unit defrosts under this mode, the indicator
lights up.
●
Continuously Drying Mode
:
In continuous operation, the unit works continuously without target
humidity until the water tank is full or the dehumidifier is switched off manually. The fan speed is adjustable.
During operation, the current humidity is shown on the display.
Note:
when the unit defrosts under this mode, the indicator
lights up.
Timer Button
Press the timer button to set the 0-24 hour timing function. Each press increases 1 hour, and the value
displays on the “88” display screen.
In the running state, use the timer function to "turn off the machine regularly".
In the standby state, use the timer function to "turn on the machine regularly".
