Setting the Clock
1.
Press the HOUR button until you reach the correct
hour. NOTE: A red LED light (PM indicator) will
appear in the upper left hand corner of the clock
face during the PM hours. Be sure to set the time
for the correct 12-hour period – AM (morning) or
PM (evening).
(Figure 6)
2.
Press the correct MIN button until reaching the cor-
rect minute.
Setting and Using the Alarm
1.
Press the ALARM button. The displayed time will
begin to flash. You are able to set the desired alarm
time ONLY while it is flashing.
NOTE: Flashing will only continue for 2-3 seconds.
Once flashing stops, the desired time can no longer
be set. Therefore, press the alarm button again and
flashing will restart. Continue setting the time.
2.
Press the HOUR button until reaching the desired
hour.
NOTE: The PM indicator also applies to the alarm.
Be sure when setting the alarm, you are setting it
for the correct 12-hour period.
3.
Press the MIN button until reaching the correct
minute.
4.
To activate the alarm move the ALARM MODE
switch from the OFF position to one of the two
modes, Beep or Windchime.
(Figure 7)
Choose
WINDCHIME to be gently awakened by the sound
of continuous chiming. Choose BEEP to be
awakened from a deep sleep.
NOTE: The Alarm Set Indicator, a green LED, will
appear on the clock display next to the alarm
symbol
(Figure 6)
to indicate the alarm is set.
8
5. The chiming or beeping of the alarm can be turned off by
pressing ANY button on the unit, except for Snooze button.
Alarm clock will automatically reset for the next day and will
be indicated by the green LED light in the clock display.
(Figure 6)
6. The entire alarm system can only be turned off by shifting
the Alarm Mode switch into the (Off) position.
(Figure 7)
;
which is confirmed by the corresponding green LED display
(Alarm Set Indicator) which will also turn off.
(Figure 6)
.
Using the Snooze Feature
When the alarm sounds (Beep or Windchime), the red LED
light will appear under the clock display
(Figure 6)
the alarm
mode indicator, to indicate the alarm is on - meaning the
alarm is going off or is in Snooze mode. You may extend
your sleep time by pressing the SNOOZE button located on
the top of the base above the clock display
(Figure 6)
. The
alarm will then stop and wait 10 minutes before sounding
again. The Snooze feature can be used up to 6 times, or an
hour, to extend your sleep time.
NOTE: After snooze button has been pressed at least once,
you may press the “O” button (Alarm 24 hour reset button)
to reset the alarm for the next day.
NOTE: The alarm clock has an auto shut-off after 30 minutes
of constant ringing.
SNOOZE
12:00
PM
HOUR
ALARM
MIN
+
Figure 6
WIND CHIME
BEEP
OFF
ALARM MODE
Figure 7
PM
Indicator
Active
Mode
Indicator
Alarm Set Indicator
9
