GB
| 10
GB
| 11
OPERATION
Battery installation
Caution: The Infrared Body Thermometer does not operate with dead batteries or external
power sources. Install new batteries.
1. Slide the battery door downward, toward the bottom of the Infrared Body
Thermometer
, and remove the battery access door;
2. Insert two pieces AAA size batteries according to the “+” and “-”;
3. Close the battery cover.
4. The product will not work without batteries installed.
5. Please obey the local laws and regulations to dispose of used batteries properly in
order to avoid environmental pollution.
6. If the thermometer will not be used regularly, remove the battery to prevent
possible damage due to chemical leakage.
7. Before using, check the appearance of the product for abnormalities, to ensure
that the product has not been dropped or sustained any external damage that
could affect its operation. If the product is damaged, do not use.
How to operate
• Forehead mode: Put on the probe cap and keep the thermometer aligned with
the middle of the forehead to measure body temperature (between or above the
eyebrows). Holding the product vertically, press the Start button - the temperature
display will immediately appear.
• Forehead scan mode: Put on the probe cap, keep the thermometer close to the
forehead and vertical, press and hold the Start button and move the thermometer
from left to right or from right to left for approximately 3-10 seconds. The maximum
temperature will be displayed on the screen.
• Please keep the forehead free of hair, perspiration, cap, scarf and etc during forehead
temperature measurement.
• Ear mode: Remove the cap and insert ear thermometer probe slightly into the ear
canal, then press the START button , measurement will be finished within 5 seconds.
• Please keep the ear canal and probe surface clean when taking ear temperature
measurement.
• You should remain in the test environment for at least 5 minutes, and measure after
the ambient temperature is in accordance with the environment.
