HoMedics PED-1200-EU, Instruction Manual

3

Inserting the batteries

1.   Open the battery compartment on the underside 

of the device.

2.   Insert batteries observing the polarity signs  

(+ and -) inside the battery compartment.  

NOTE:

 The batteries are stacked with one of the 

batteries behind the other two.

3.  Close the battery compartment. 

How to use

1.   Ensure that your feet are clean and dry.

2.   Use the switch to select a power setting; 

   For sensitive skin, or softer skin use the LO 

setting.

  For harder skin use the HI setting.

3.    Using light pressure place the surface of roller 

onto the heel or sole of your foot and gradually 

move the device around to target areas of hard 

skin. Do not use on a single area for more than 4 

seconds at a time.

4.   Check the results throughout. Once you are happy 

with the results turn the switch to OFF.

5.   Rinse your feet with clean water & dry before 

applying your favourite foot cream.

Cautions

Before use, make sure that the roller is in good condition. Any malformation, 

distortion or damage may cause skin injury.

DO NOT APPLY EXCESS PRESSURE OR CAUSE THE MOTOR TO STOP ROTATING. FOR 

BEST RESULTS, RUN THE UNIT GENTLY OVER THE SKIN. THIS WILL ENSURE SOFT, 

SAFE AND SMOOTH REMOVAL OF DEAD SKIN.

INSTRUCTIONS FOR USE:

PRODUCT FEATURES 

Main body

Power switch

3x AAA batteries

Changing the rollers

To remove the roller.

1.  Ensure the switch is in the OFF position.

2.   With one hand press the release button on the 

side of the device. 

3.   With the other hand lift out the roller. TIP: It’s 

easier to lift the roller out from the end closest to 

the release button.

To insert a new roller.

1.   Loosely position one of the roller pins into the recess on the end furthest from 

the release button. 

2.   Push the other end of the roller into place using the groves to guide it into 

position.

3.  The roller will secure into place with a click.

MAINTENANCE AND STORAGE

•  Always turn the device off before cleaning it.

•   Only clean the device with the supplied brush or a dry cloth. Do not use 

chemical agents including benzene, alcohol etc.

•   Remove batteries if equipment is not going to be used for extended periods 

of time, and store batteries in a cool dry place away from direct sunlight and 

metal objects.

•   If motor power seems reduced, replace the batteries.

•   If roller surface becomes worn or less abrasive, fit a new roller.

Coarse roller:  

blue edge

Cleaning brush

Extra coarse roller: 

white edge

Release button

Fine roller: grey edge  

(where supplied)

GB