PRODUCT FEATURES:
4
5
fig. 1
Round massage head
CHARGING YOUR DEVICE
1.
To charge the product, plug the charging cable into
a USB socket and connect the cable to the charging
socket on the bottom of the handle (fig.2).
Please use Australia approved power ad
a
pt
o
r
to power the product.
2.
Once the charging cable is connected, the charging
indicator LED will illuminate and blink red. As soon
as the device is fully charged the LED indicator will
change to blue.
3.
Once the product is fully charged, disconnect it from
the power supply.
4.
The product requires 5-6 hours of charging for a full
charge and will last for approximately 1 hour of use.
1.
Select the desired massage head and fasten it into
the socket on the front of the massager (fig.3). It
should be finger tight only as overtightening may
cause damage to the product.
2.
Press and hold the power on/off/power level button
for 3 seconds to turn the device on.
3.
Pressing the on/off/power button again will cycle
through the power levels:
• Press x 1: LO
• Press x 2: MID
• Press x 3: HI
• Pressing the button again will repeat this
sequence
DO NOT USE THE PRODUCT FOR OVER 30
MINUTES CONTINUOUSLY.
IF THE PRODUCT IS USED FOR OVER 30
MINUTES IT MAY TRIGGER THE HEAT
PROTECTION FEATURE AND STOP
AUTOMATICALLY.
PLEASE WAIT FOR AT LEAST 30 MINUTES FOR
THE PRODUCT TO COOL OFF BEFORE
RE-USING.
CLEANING YOUR DEVICE.
• Make sure the device is unplugged from any power
supply and allow to cool before cleaning. Clean only
with a soft, slightly damp sponge.
• Never allow water or any other liquid to come into
contact with the appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass/furniture
polish, paint thinner, etc to clean.
INSTRUCTIONS FOR USE:
fig. 2
fig. 3
Conical massage head
U-shaped massage head
On/off/power
button
USB charging cable
Adaptor plug not included
Operation
indicator light
Charging
indicator LED
Power socket
4.
Gently move the massage head over the part of
the body you wish to massage at first, then gently
apply more pressure as desired. If you are a first
time user it is recommended that you start on
power level 1 and press gently.
5.
A long press on the on/off/power button for
1 second will turn the massager off.
6.
The product cannot be used while charging
WARNING. Adaptor output charging voltage of 5Vdc
and 1A must not be exceeded. If the voltage input
exceeds 5V, the massager will terminate charging and
the indicating light will blink in blue in order to remind
you to use the correct voltage adaptor. Adaptor must be
removed from the socket when not in use.
USING YOUR DEVICE
Summary of Contents for PGM-200-AU
Page 1: ......
