6
G
B
INSTRUCTIONS FOR USE:
Massage Function
1. Plug the adaptor into a 220-240V mains outlet.
2. Connect the adaptor lead to the massager power supply cord.
3. To turn on, press power button once (Figure 1).
4. To activate Shiatsu massage, press Shiatsu button. To change direction press (Figure 1).
5. To activate soothing heat with the massage, press the heat button (Figure 1). Massage heads will glow
red (Figure 2). Allow a few moments for the heating action to warm up.
6. When finished press the power button again to turn off all massage and heat functions and unplug
the pillow.
NOTE:
• The massage cushion should only be used for a maximum of 15 minutes at any one time.
• The Shiatsu Pillow is designed for use on the neck, back and shoulders (see Figures 3 and 4).
• Only gentle force should be exerted against the pillow in order to eliminate risk of injury.
• Always remember to switch the appliance off when not in use.
• Take care to position the product where it will not damage wooden or upholstered surfaces.
• For the neck and shoulders it may work better to use the pillow upside down (as shown in Figure 5).
• The elasticated Velcro strap (situated on the rear of the pillow) can be used to secure the pillow to the chair
back (see Figure 6).
CAUTION:
To avoid pinching do not lean on Shiatsu back massage mechanism in the pillow when adjusting your
body position.
Do not jam or force any part of your body in the moving massage mechanism.
(Figure 2)
(Figure 3)
(Figure 1)
(Figure 5)
(Figure 4)
(Figure 6)
IB-SP35HEU-0714-01_Layout 1 04/07/2014 10:50 Page 6
Downloaded from www.vandenborre.be
