Assembly
1.
Hold the head and insert it into the inlet. When inserting make sure
the head is slanted (see figure 1)
2.
Move the head anticlockwise so that it is fastened tightly. Once the
handle is screwed in it will now be locked into place (see figure 2)
3.
Place the snake into the head, long end first and turn to feed the
screw slightly until it is set into the motor housing (see figure 3).
4.
Place the cutting blade onto the snake shaft with the blade facing the
front (see figure 4). If it is not fitted properly the meat will not grind.
5.
Place the desired cutting plate next to the cutting blade fitting the
protrusions in the slot (see figure 5).
6.
Support or press the center of the cutting plate with one finger, then
screw the fixing ring tight with another hand (see figure 6). Do not
over tighten.
7.
Place the Hopper Plate on the head and fix it into position.
8.
Place the Homegear Meat Grinder on firm even surface
9.
The air passage at the bottom and the side of the motor housing
should be kept free and unblocked.
Summary of Contents for HBHG-0200
Page 1: ...1200W Meat Grinder...
