o
Open the door of the dishwasher and then remove the lower
basket. The basket should be empty when you remove it.
o
Unscrew and remove the cap from the water softener.
o
Fill the container with water.
IMPORTANT: It is only necessary to do this when you fill
the container with salt for the first time.
o
Pour salt into the water softener, using the funnel that is
supplied with the appliance. You should add approximately 2 kg
of salt into the water softener.
o
It is perfectly normal for a small amount of water to come out of
the water softener, whilst you are filling it with salt. This does
not mean that the water softener is filled with the correct
amount of salt.
o
Refit and fully tighten the water softener cap.
o
The salt indicator light (E) will go out shortly
after you have filled the water softener with
salt. When the salt indicator (E) lights on the
control panel, then you should follow the
filling with dishwasher salt procedure again.
o
It is recommended that you run a RAPID program, without any
dishes loaded into the dishwasher, after filling with salt to
remove any spilt or excess salt.
o
IMPORTANT: You do not need to pour water into the
container when you subsequently fill the water softener
with salt.
11
Summary of Contents for DWI600
Page 51: ...51 ...
