8
9
-Lighting
Press the light switch to turn the light on or off.
-Temperature Control
The temperature range for the wine cooler is 54OF - 66OF.
Press the increase temperature button to increase the temperature one degree at a time.
Press the decrease temperature button to decrease the temperature one degree at a time.
The selected set temperature will flash a few times, then the control panel will display the
current temperature inside the wine cooler.
When the set temperature is reached, the automatic temperature control system will start to work.
To control the Wine Cooler temperature, adjust the temperature control buttons as shown below.
OPERATION
Energy Conservation
• The cooler should be placed in a room that is dry and ventilated. The cooler cannot be placed under direct
sunlight or next to a heat source (such as a radiator, stove, etc.), and a suitable insulation board must be
applied if necessary.
• Try to shorten the opening time of cooler’s door.
PROPER USE OF WINE COOLER
INTRODUCTION TO THE WINE COOLER’S FUNCTIONS
The Wine Cooler is not
reaching the desired
temperature.
The Wine Cooler does
not work.
Frost has formed
inside the cooler.
The cooler is too close to a heat source.
There isn’t sufficient ventilation at the
back or sides. The door is opened too
frequently or for too long.
There is a power failure.
A house fuse has blown.
There may be too much humidity.
The ambient temperature might
be too low.
Reduce the frequency of opening the door.
Keep the cooler away from sunlight or
other heat sources. Place the wine cooler
in a more open space for ventilation.
Make sure the cooler is plugged in
and the power socket is turned on.
Replace the broken fuse in your
meter box.
Unplug to defrost. Plug in again
after defrosting is completed.
Set at a slightly higher temperature.
DISCONNECTING THE WINE COOLER
CLEANING YOUR WINE COOLER
CLEANING
TROUBLESHOOTING
POSSIBLE CAUSES
POSSIBLE CAUSES
PROBLEM
NOTE: Do not use hard brushes, wire brushes, abrasives, organic solvents, boiling water,
acid, or alkaline items as this may damage the cooler surface and interior.
Unplug the power plug from the socket to disconnect the cooler.
Follow the cleaning procedure below:
1. Wash the magnetic door seals with warm, soapy water and dry.
2. Wipe exterior with a damp, soapy cloth to rinse and dry with a towel. For stubborn stains, use silicon wax.
3. Wash shelves and other removable parts in warm soapy water to rinse and then dry. Wash interior with
baking soda (3 tablespoons to a liter of water) or warm soapy water to rinse and then dry.
4. Reconnect to power when the cooler is clean and dry.
Operation Notes
• Let the wine cooler operate for 1 hour before placing wine bottles in.
• Once temperature is set, allow 1-2 hours to reach desired temperature.
• The minimum temperature for this unit is 54°F, which means it is not designed to achieve
proper serving temperatures for Champagne or other sparkling wines.
• This unit is not recommended for use in spaces that get warmer than 80°.
Control Panel
Temperature Control Buttons
Increase
Decrease
Light Switch
Temperature Indicator
