7
Programming Door Locks
To program an RF entry door lock to HomeLink® , follow the steps outlined below:
1. Press and hold the desired HomeLink button you wish to use to operate the entry door lock. When pressed, the
HomeLink indicator light should be a slow, repetitive flash. If it does not do this, continue to hold the button for 20
seconds. After 20 seconds, the indicator light should begin to flash. DO NOT RELEASE!
2. With the HomeLink button pressed and the indicator light flashing slowly, position the door lock’s handheld
transmitter between 1 and 3 inches away from the HomeLink surface.
3. Press the door lock’s handheld transmitter button (the same button used to lock and unlock the door lock) until the
HomeLink indicator light begins to flash rapidly. Release both buttons.
4. Return to the door lock and press and release the Learn Button on the Electronic Dead Bolt Power Board.
5. Once this Power Board beeps three times, return to the vehicle and press and release the programmed HomeLink
button three times. The third press should activate the door lock.
If you cannot get your door lock to program, visit our Web site at www.homelink.com for further assistance.
Programming Security Systems
To tie an existing or new home security system into the convenience of your vehicle's HomeLink Wireless Control
System, simply arrange installation through your local security dealership of the ITI brand HomeLink Security Interface.
The HomeLink Security Interface is engineered exclusively by ITI, a leading manufacturer of state-of-the-art security sys-
tems for commercial and residential use. The interface is compatible with many brands of security systems, including the
ITI brand.
For dealer locator information or additional comments and questions, please visit our Web site at www.homelink.com.
Programming Other RF and Non-RF Devices
To program other devices into HomeLink (e.g., home appliances) please contact us on our Web site, www.homelink.
com, for specific instructions based on your programming needs.
