Page 12
STOP
OP
1
2
3
STARTING AND STOPPING
See Figure 12 and 13.
TO START A COLD ENGINE:
1. Lay the trimmer on a flat, bare surface.
2. Push the primer bulb 8 to 10 times.
3. Set the choke lever to the choke position
.
4. Squeeze the throttle trigger to the full throttle position.
5. Pull the starter until the engine tries to run. No more
than 6 pulls.
6. Set the choke lever to the half choke position
.
7. Hold the trigger and the pull starter rope until the engine
runs.
8. Run the engine 30 to 45 seconds at full throttle (with the
trigger depressed fully) on half choke position
to
warm up the engine. Move the choke lever to the run
position
.
TO START A WARM ENGINE:
1. Move the choke lever to the run position
.
2. Hold the trigger and pull the starter rope until the engine
runs.
TO STOP THE ENGINE:
To stop the engine, push and hold the
STOP
button until the
engine stops.
HALF
CHOKE
POSITION
PRIMER BULB
CHOKE LEVER
STOP BUTTON
CHOKE
POSITION
RUN POSITION
Fig. 13
Fig. 12
THROTTLE
TRIGGER
PRIMER BULB
OPERATION
