Page 7
If your unit has been preassembled, check each step to make
sure the unit has been properly assembled.
FRONT HANDLE
See Figure 2.
1. Remove the front handle, bolt, and wing nut from the
Owner’s Kit.
2. Install the front handle onto the top side of the drive
shaft housing and move it to a comfortable position.
3. Place the bolt through the front handle as shown, then
install the wing nut.
4. Tighten wing nut securely.
GRASS DEFLECTOR WITHOUT EDGER
GUIDE - TRIMLITE AND TRIM ‘N EDGE
See Figure 3.
1. Remove wing nut, flat washer, lock washer, and bolt
from the Owner’s Kit.
2. Place grass deflector over shaft and bracket.
3. Install bolt through the slots in the tabs on grass deflec-
tor and bracket on shaft housing.
4. Install flat washer, lock washer and wing nut.
5. Tighten Securely.
GRASS DEFLECTOR WITH EDGER GUIDE -
TRIM ‘N EDGE ONLY
EDGER GUIDE ASSEMBLY
See Figure 4.
1. Assemble the two plastic pieces of the edger guide
together using the short bolt, flat washer, lock washer
and wing nut.
2. Slide the edger guide to adjust it to the desired trimming
length.
3. Tighten the wing nut securely.
GRASS
DEFLECTOR
BRACKET
BOLT
WING NUT
Fig. 3
WING NUT
FRONT HANDLE
BOLT
Fig. 2
FLAT
WASHER
LOCK WASHER
ASSEMBLY
EDGER GUIDE
PIECES
SHORT BOLT
FLAT WASHER
LOCK
WASHER
WING NUT
Fig. 4
