Page 10
ASSEMBLY
WARNING:
Stop the engine and disconnect the spark plug wire
before installing parts, making adjustments, cleaning, or
when not in use. Failure to do so could result in possible
serious personal injury.
ASSEMBLING THE BLOWER TUBES
See Figure 3.
Screw the nozzle onto the blower tube and tighten
securely. Check tightness after initial run and retighten if
needed.
Place tube clamp around the neck of the blower housing
outlet. Do not tighten the knob yet.
Align the locking tab on blower tube with the slot in the
blower housing outlet; push the tube into the housing.
Twist to lock into place.
Rotate the tube so the nozzle is pointing upward as
shown. Tighten the knob securely.
To remove the tubes, loosen the knob on the tube clamp.
Rotate the tubes to unlock them; remove tube from the
blower housing outlet.
INSTALLING THE VACUUM BAG
See Figures 4 - 5.
Remove the nozzle and blower tube from the blower.
Unzip the vacuum bag and place the bag adaptor inside
as shown.
Align the locking tab on the bag adaptor with the slot in
the blower housing outlet; push the bag adaptor into the
housing. Twist to lock into place.
Tighten the wing nut securely.
Rotate the vacuum bag until the shoulder strap is
upright.
Make sure the vacuum bag is zipped and closed before
starting the unit.
Fig. 4
Fig. 3
Fig. 5
BAG ADAPTOR
VACUUM BAG
NOZZLE
UPPER
BLOWER TUBE
KNOB
