Page 9 — English
Set choke lever to the
FULL.
Set the throttle to the
FULL ( ) position.
Pull the starter grip sharply until engine attempts to run
(no more than 4 pulls).
Set the choke lever to the
HALF CHOKE position.
Pull the starter grip until the engine runs. Do not pull the
starter grip more than six (6) times.
NOTE: If the engine does not start, return to the FULL
CHOKE position and repeat the steps that follow.
Allow the engine to run for 10 seconds, then set the choke
lever to the
RUN position.
TO STOP THE ENGINE:
To stop the engine, set the throttle to the stop position
“ ”.
HOT RESTART OF THE ENGINE:
Set the choke lever to the
RUN position.
Set the throttle to the
FULL ( ) position.
Pull the starter grip until the engine runs.
IF ASSISTANCE IS REQUIRED STARTING THIS
PRODUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-242-4672
OPERATING THE BLOWER
See Figure 4.
WARNING:
Never run the unit without the blower tubes installed or
the air inlet cover securely closed. Use of an improperly
assembled unit could result in serious personal injury.
Start the blower. Refer to
Starting and Stopping earlier
in this manual. Hold the blower with the upper handle in
your right hand.
WARNING:
Do not place blower on top of or near loose debris or
gravel. Debris may be sucked into blower intake vent
resulting in possible damage to the unit and could result
in serious personal injury.
WARNING:
Always hold the blower away from your body with the
handle in your right hand when operating, keeping clear-
ance between your body and the product. The muffler
side of the blower should be away from your body. Any
contact with the housing can result in burns and/or other
serious personal injury.
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
Operate power equipment at reasonable hours only - not
early in the morning or late at night when people might
be disturbed. Comply with the times listed in local ordi-
nances.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches, and
gardens.
Operate blower at the lowest possible throttle speed to
do the job.
Check your equipment before operation, especially the
muffler, air intakes, and air filters.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
Hold blower, as shown in figure 4, so the air stream can
work close to the ground.
After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
OPERATION
Summary of Contents for UT09520
Page 41: ...Página 15 Español NOTES NOTAS ...
