46
Configuration menu
•
Selection of electrical installation material for safeguarding shut-
off conditions;
•
IP protection types;
•
Installation of electrical installation material;
•
Type of supply network (TN system, IT system, TT system) and
the resulting connecting conditions (classical zero balancing,
protective earthing, required additional measures etc.).
6
Configuration menu
When using the wall thermostat without Homematic IP Access Point, you
can select the following modes via the configuration menu after set-up
directly on the device and adjust the settings to your personal needs. To
do this, proceed as follows:
•
By pressing and holding the menu button
(E)
for at least 2 s, you
will be entering the configuration menu.
•
Select the desired icon via the plus and minus buttons
(D
+ F)
by
pressing the menu button briefly to change the settings of the
different menu items.
Press and hold down the menu button
(E)
to get back to the previous
level.
The menu automatically closes without applying changes if there is no
operation for more than 1 minute.
6.1
Automatic mode
6.2
Manual operation
6.3
Offset temperature
6.4
Programming of heating profiles
6.5
Operating lock
6.6
Date and time
6.7
Holiday mode
Summary of Contents for 154666
