47
Configuration menu
6.1
Automatic mode
Switching from manual to automatic mode is only possible if the
date and time have been set.
In automatic mode, the temperature is controlled in accordance with
the set heating profile. Manual changes are activated until the next point
at which the profile changes. Afterwards, the defined heating profile will
be activated again. To activate the automatic mode, please proceed as
follows:
•
Press and hold down the menu button
(E)
to open the
configuration menu.
•
Select “Auto” via the plus and minus buttons
(D
+ F)
in the menu.
•
Confirm with the menu button.
To confirm, the symbol flashes twice and the device changes back to
automatic mode.
6.2
Manual operation
In manual mode, the temperature is controlled in accordance with the
current temperature set via the push-buttons
(D
+ F)
. The temperature
remains activated until the next manual change. To activate the manual
mode, please proceed as follows:
•
Press and hold down the menu button
(E)
to open the
configuration menu.
•
Select “Manu” via the plus and minus buttons
(D
+ F)
in the menu.
•
Confirm with the menu button.
To confirm, the symbol flashes twice and the device changes back to
manual mode.
Summary of Contents for 154666
