48
Configuration menu
6.3
Offset temperature
As the temperature is measured on the room thermostat, the temperature
distribution can vary throughout a room. To adjust this, a temperature
offset of ±3.5 °C can be set. If a nominal temperature of e.g. 20 °C is set
but the room presents with only 18 °C, an offset of -2.0 °C needs to be
set. An offset temperature of 0.0° is set in the factory settings. To adjust
the offset temperature, please proceed as follows:
•
Press and hold down the menu button
(E)
to open the
configuration menu.
•
Select “Offset” via the plus and minus buttons
(D
+ F)
in the menu.
•
Confirm with the menu button.
•
Select the desired offset temperature using the plus or minus
button and confirm with the menu button.
To confirm, the temperature flashes twice and the device changes back
to the standard display.
6.4
Programming a heating profile
In this menu item, you can create a heating profile with six heating and
cooling phases (13 change settings) according to your personal needs.
•
Press and hold down the menu button
(E)
to open the
configuration menu.
•
Select “Prg” using the plus or minus buttons
(D
+ F)
and confirm
with the menu button.
•
In the menu item “dAy”, use the plus and minus buttons to select
single days of the week, all weekdays, the weekend or the entire
week for your heating profile and confirm with the menu button.
•
Confirm the start time 00:00 pm with the menu button.
•
Select the desired temperature and start time using the plus or
minus button and confirm with the menu button.
•
The next time is shown in the display. You can adjust the time via
the plus or minus buttons.
•
Select the desired temperature for the next time period using the
plus or minus button and confirm with the menu button.
Summary of Contents for 154666
