45
Start-up
In order to use the door opening function, the door seals
must be intact and designed so that the door will open on
its own after completely unlatching the lock because of
the expansion of the door seal.
5.1.2
Lock cylinder requirements
The door lock drive mounted directly on the cylinder lock
(F)
of the door (
see figure 2
); when the appropriate key is
inserted, the drive causes the cylinder to move. Accord-
ingly, the cylinder lock must be dimensioned so that it juts
out on the inside of the door by 8 –15 mm more than the
handle fitting.
Determine the dimensions of the required lock cylinder
using fig. 3.
When selecting the lock cylinder, the inner dimension
(G)
and outer dimension
(H)
of the cylinder are significant.
It is always measured from the outsides of the lock cylin-
der including door fitting to the fixing screw
(I)
.
Once you have determined the inside and outside dimen-
sions of your lock cylinder, check whether the inside di-
mension overlaps by 8 – 15 mm for the installation of the
door lock drive.
If this is not the case, add 8–15 mm to the inside dimen-
sion (ideal 10 mm) to find the appropriate standard size.
Summary of Contents for HmIP-DLD
