55
Replacing batteries
latch it into place.
• Pay attention to the flashing signals of the LED
(C)
after inserting the batteries (see “9.2 Error codes
and flashing sequences” on page 57).
Once the batteries have been inserted, the device will
perform a self-test (approx. 2 seconds). Afterwards,
initialisation is carried out. The test display will indicate
that initialisation is complete: orange and green lighting.
Open the door by pressing and holding the unlock button
(B)
to detect the lock status.
Remove or change used batteries immediately to
prevent the batteries from leaking.
Always replace all batteries in the device and use
batteries of the same type/from the same manu-
facturer only.
If the battery voltage is getting low it is displayed
via the app. Furthermore, the device emits an
audio signal and the device LED (
C
) flashes orange
after every basic function actuated. Change the
batteries in this case. The settings will not be lost.
Contact with batteries that are dead or damaged
can cause skin irritation. Use protective gloves in
this case.
Summary of Contents for HmIP-DLD
