16
• Auswahl des Elektro-Installationsmaterials zur Si-
cherstellung der Abschaltbedingungen;
• IP-Schutzarten;
• Einbau des Elektroinstallationsmaterials;
• Art des Versorgungsnetzes (TN-System, IT-
System, TT-System) und die daraus folgenden An-
schlussbedingungen (klassische Nullung, Schutz-
erdung, erforderliche Zusatzmaßnahmen etc.).
7 Inbetriebnahme
7.1 Batterien einlegen (wechseln)
• In montiertem Zustand lässt sich der Taster ein-
fach aus dem Rahmen und von der Montageplatte
ziehen. Fassen Sie den Taster seitlich an und zie-
hen sie ihn aus dem Rahmen heraus. Ein weiteres
Öffnen des Gerätes ist nicht erforderlich.
• Drehen Sie den Taster auf die Rückseite, um die
Batterien einzulegen bzw. sie zu entnehmen.
• Nach Entnahme der Batterien sollten ca. 10
Sekunden gewartet werden.
• Legen Sie zwei LR03 Batterien (Micro/AAA)
polungsrichtig gemäß Markierung in die Batterie-
fächer ein.
• Setzen Sie den Taster wieder in den Rahmen.