37
Start-up
5.2
Mounting
Please read this entire section before starting to
mount the device.
You can use the supplied clip-on frame
(A)
to mount the
wall-mount remote control or easily integrate it into an
existing switch (see sec. „5.1.1 Teaching-in to the Home-
matic Central Control Unit CCU2“ on page 35).
If you want to mount the wall-mount remote control
with the supplied clip-on frame, you can use
• the supplied double-sided adhesive strips or
• the supplied screws
to fix it to a wall.
5.2.1
Adhesive strip mounting
For mounting the assembled device with adhesive strips,
please proceed as follows:
• Choose a site for installation.
Make sure that the mounting surface is smooth,
solid, non-disturbed, free of dust, grease and sol-
vents and not too cold to ensure long-time ad-
herence.
• Fix the adhesive strips
(H)
on the back side of
the mounting plate
(G)
in the provided area. You
