42
Holding time:
Briefly press the button "Unlock", the holding time is extended (approx. 2.5
seconds).
Briefly press button "Lock": Short holding timeBriefly press the "Setup" but-
ton after these settings are complete.Now, all settings are saved, the door
lock drive unlocks the lock and moves it to the neutral position.
The display shows the symbol "Unlocked" and "M".
This completes the basic settings.
7.2
Teaching remote controls and buttons
No remote control has been taught for the door lock drive when the system is
delivered. Radio operation is therefore impossible.
The first remote control that is taught is automatically the "Master" remote
control. Memory location "1" is reserved for this. In order to authenticate
other teach procedures (from other buttons(pairs) as well on the master
remote control as well), this is required!
Teach the first button pair of the Master remote control:
Press the top button "Unlock" for approx. 2 seconds, to start the teach
process.
Teach mode is ended automatically after teaching is successful, after
actuating any button on the drive or after 20 seconds after entry.
A beep is then emitted and "M" is shown on the display. Memory location
"1" is shown on the LC display.
The symbols for radio reception and "Unlock" flash; the door lock drive is
ready for teaching. Proceed as follows:
• Set the remote control to configuration mode and briefly press one of the
buttons of the button pair to be taught.
Briefly pressing the button pair that has now been taught can be used for
locking and unlocking, a longer press of the "Unlock" button can be used
for opening the door. This first taught button pair is for authenticating further
teach processes.
Summary of Contents for KeyMatic HM-Sec-Key
Page 50: ...50...
Page 51: ...51...
Page 52: ...52 eQ 3 AG Maiburger Stra e 29 D 26789 Leer www eQ 3 com...
