14
white
white/black
24 vdc
com
External
Receiver
6
Wired Wall Button
com
n/o
8
Black
Red
jumper
wire
3
2
4
5
3
1
6
4 3 2 2 1
IR Beams
green (4) grey (3) white (2) red (1)
TYPICAL WIRING DIAGRAM HERDO1
Information for Service Personnel
20
Battery of the remote control:
The batteries in the remote have an extremely long life.
If the trans mission range decreases, the batteries must be replaced. Batteries are not covered by the warranty.
Replacing battery (CR2032 or equivalent):
To replace battery, turn remote control around and open the case with a
screwdriver. Lift cover and lift control board below. Slide battery to one side
and remove. Observe polarity of battery!
Assemble again in reverse direction.
REPLACE BATTERIES IN REMOTES
To prevent SERIOUS INJURY OR DEATH: observe the following instructions for the battery
- NEVER allow small children near batteries.
- If battery is swallowed, immediately notify doctor.
- Danger of explosion if battery is replaced improperly.
- Replacement only by identical or equivalent type.
- Dispose of old battery properly. Batteries should not be treated as household waste. All consumers
are required by law to dispose of batteries properly at the designated collection points.
- Never recharge batteries that are not meant to be recharged.
- Do not short-circuit batteries or take them apart.
- If necessary, clean contacts on batteries and contacts
before loading.
- Never expose batteries to excessive heat such as sunshine, fire or the like!
N2966
N2966
N2966
N2966
21
or
12
VD
C
Pb
Cd
Hg
