Step 5
Fasten smaller floor section to
both the foundation 4x4 and
2x4 of larger floor section with
3” nails (10 or 12 penny nails).
Step 6
Once sections are attached,
install the floor boards with a
tongue and groove fit. Fasten
boards to floor joist with 2 1/2”
screws.
Step 4
Once floor boards are off,
make sure the 2x4 is sitting
level on the 4x4 foundation
board and flush with the 2x4 of
larger floor section.
Step 7
Set left side-wall plum, keeping both
ends flush with the ends of the floor.
The base plate (2x4 frame) should sit
in 3 1/2”, as pictured. From the outside
of the wall, nail through siding into the
floor, making sure that the bottom 2x4
of wall is tight against the floor.
Then, from inside wall nail through 2x4
bottom every 12 in.
© HomePlace Structures