Easy Start
Page 8 of 19
4 PLCConfig Installation
Overview
The installation of the Turbo Powerline Ethernet Bridge will only take minutes .Laying long wires
throughout the house is not necessary . The device is also plug-and-play , which means as soon as two
Powerline devices are plunged into the power outlets under the same electrical circuit , both devices
should start communicating . The traditional RJ-45 LAN cable is simply replaced by in-house electrical
wire . No additional software utility and driver are needed for the device to become operational. However ,
the enclosed software utility allows advanced users to manipulate the device for different needs , for
example , device discovery ,changing default settings , increasing security , management , etc . If you
decide to install the enclosed software utility , just simply install the software CD included in the box and
physically connect the devices into computers and power outlets .For further assistance , please refer to
our Frequently Asked Questions section .
Running the Install Shield Wizard
Please insert the CD into your CD-ROM and wait a moment for the setup screen to come up . If the
CD-ROM does not run the CD , please click on 'Start' at the bottom left of your screen ( for most
Microsoft Windows ) and go to 'Run' .Type in : (CD Drive Letter ): \eth\setup . exe and click 'OK' .
Once the software is loaded it will display a dialog such as :
Please click on 'Next' to continue the installation .
