-12-
ALFA IN a.s. ©
www.alfain.eu
Fig. 3 – Parts of the torch QTB 180
Pos.
No.
Description
17
6067
Torch neck MG-150 with a valve
18
6066
Tip Adaptor for Torch MG-150 with a valve,
MG-160
19
PB1527-06
Girder 0.6 M6/6/25 MB PARKER
19
PB1527-08
Girder 0.8 M6/6/25 MB PARKER
20
145.D186
Nozzle M12 Bare
21
6068
Fixing nut for handle torch MG-150 with a
valve
22
6070
Trigger for MG-150 with a valve
23
QTB104
Handle QTB 180
24
6068
Fixing nut for handle torch MG-150 with a
valve
7. GETTING STARTED
Getting started must be consistent with technical data and conditions of use.
Homer MG-160 is equipped with a roller with two grooves - 0.6 and 0.8 mm.
These grooves are intended for steel or aluminium solid wires of corresponding
diameter. For the flux cored self-protective wire diameter of 0.8 mm, 0.9 mm
or 1.0 mm is used the groove of 0.8 mm. For all types of wires is used the roller
with knurled groove (supplied).
1. Connect the earthing clamp
4
to the welding piece.
2. Plug the mains plug to 230 V mains.
3. Switch the machine on by the ON/OFF switch.
INSERTING THE WIRE
1. Open the side cover of the wire feeder space.
2. Put the wire spool on the spool holder
10
.
